|
|
Rock Hard Rear Bumper
Jeep JK Wrangler
Patent Pending
The Rock Hard Jeep JK Wrangler Rear Bumper/Tire-Carrier is the only JK rear bumper on the market today that is made out of 1/4" thick plate steel. Designed with tapered ends for increased departure angles, this bumper will hold up to a 38" tire, comes standard with an integrated Class 2 hitch receiver, CB antenna mount, a horizontal Hi-Lift Jack mount with padlock provision and two 5/8" x 2-1/2" CNC D-Ring shackle mount with tabs that are welded on front, go through bumper and then are welded on the backside as well. All necessary hardware required for the installation is provided and an optional muffler shield, jerry can mounts and a trail rack are all available for purchase separately.
Rock Hard JK Rear Bumper/Tire-Carrier Only
Powder Coated Black
Part #RH5001
$949.95
Features
|
 |
 |
The Rock Hard Jeep JK Wrangler bumper tire carrier swings on 1 1/4" shaft, 2 3/4" hub with upper and lower sealed tapered roller bearings. Zerk fittings allow you to fill the hinge with grease. Also, notice the A-Frame swing stop built into the bumper. |
 |
 |
Photos of what the Rock Hard JK Rear Bumper/Tire-Carrier looks like mounted on a Jeep JK Wrangler complete with over sized spare tire and Hi-Lift Jack. |
 |
 |
Easy open latch. Just lift lever to open
self-latching design. To close, simply push it shut.
Also included is a double safety latch with hard plastic rest and rubber stop for a rattle free operation. |
| |
 |
Spring loaded auto-locking pin system. Tire carrier locks in the open position so it will not swing back at you.
To close, just lift tee handle on the pin and let it swing shut. |
| |
 |
The Rock Hard Jeep Bumper has an Integrated class 2 trailer hitch comes complete with safety change mounts. |
|
|
Optional right and left tank mounts works with NATO or USA cans. Rattle Free J - Bolt Mounting for Cans and Provisions for Padlocks are provided.
U - Bolt Mounting to the swing out tire carrier allows for easy installation. |
|
 |
This is what the Rock Hard gas tank mounts look like with NATO or USA cans on them. |
| |
 |
Left gas tank mount has an additional CB Antenna Tab. |
|
 |
The optional Rock Hard Rock Rack
(RH2004) has an inside measurements or 5 1/4" deep, 18 1/4" wide and 38 1/2" long. |
| |
|
This photo shows the Rock Hard Rock Bumper from the back side complete with optional Rock Rack and Tank Mount and CO2 Tank Mount. |
| |
 |
This photo show the optional muffler skid plate that is available for this rear bumper. |
| |
 |
In order to install an optional 3rd brake light (RH2002TL), the center hole on your wheel must be 2 - 1/2" or larger. Installation only requires you to splice the light onto your factory light wiring.
Longer wires, screws and required connectors are Included. |
 |
 |
This license plate relocation (RH4007) bracket will allow you to relocate your rear license plate to the center of your spare tire. Quick release thumb screw allows for easy removal on the trail. An optional 3rd brake/license plate light (RH4006) can also be added. |
| |
|
|
|
| |
